BC-01 / BC-02 / BC-03 / BX-3	WHAT YOU NEED TO START SEPOMs Refill Inkbottle (included) Screw (included) Rubber Plug (included) Cap Pin (included) Tissue Papers Printer cartridge
Refill Method:   1. Remove Plastic Plug Remove cartridge from printer according to printer manual. With provided screw, remove the plastic plug of the ventilation hole located at the side of the cartridge.
2. Insert Rubber Plug into Vent Hole Insert SEPOMs rubber plug with the smaller hole facing down into the ventilation hole as indicated.
3. Poke a Hold with Cap Pin	Tap the top of the inkbottle so no ink remains at the top portion. With cap pin, puncture a hole at the top of the inkbottle.
4. Squeeze and Fill
With ventilation hole upright, insert the tip of the inkbottle into the rubber plug hole. To refill, gently squeeze the inkbottle for 2 seconds then release. Repeat this process until ink begins to appear at the print head, located at the bottom of the cartridge. Approx. 3/4-1 bottle
5. Test the Cartridge	Remove the inkbottle and wipe off excess ink on the cartridge. Do not remove rubber plug. Gently press the print head onto a piece of tissue paper. If ink stains on the tissue paper, it is ready for use. Replace cartridge into printer according to printer manual. If there is no ink stain, it may be due to the present of air buddles. (refer to point 6)
6. Shake the Cartridge
Wrap a tissue paper over the print head, hold the cartridge with the print head facing downward and shake the cartridge a few times to let the air out from the print head, then test it on a piece of tissue paper again. If there is still no ink stain, the print head may be clogged by dried ink. Use SEPOMs Print Head Liquid Cleaner to dissolve the dried ink.
CAUTION! To preserve unused ink, insert cap pin into the top of the inkbottle, and store in a dry, cool place. Do not allow cartridge to dry out. This may clog the print head and affect the print quality.

top  

Copyright © 2004-2006 SEPOMs Singapore. All Rights Reserved.